This model is restricted by licensing terms.
View license.
11 Likes23 DownloadsJuly 17, 2024
This model is restricted by licensing terms.
View license.
Watch stands are available in 3 versions: Upright, Minimalist, and Slanted (listed as separate models).
Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 3 Layer Height: .2 Supports: NONE Print Orientation: Place the side of the watch holder against the build plate.
Additional Parts Required: • Double Sided Tape • Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)
Assembly: • Add a small amount of double sided tape to the base of the watch mount to keep it secure during use.
Category:
11 Likes23 DownloadsJuly 17, 2024
This model is restricted by licensing terms.
View license.
11 Likes23 DownloadsJuly 17, 2024
This model is restricted by licensing terms.
View license.