A light, high strength shelf that lets your soap dry and keeps it from sliding.
Print Recommendations Print Material: PLA
Infill Type: Honeycomb
Infill Percent: 6%
Top Layers: 0 (this is critical to expose the infill and provide draining)
Bottom Layers: 0 (this is critical to expose the infill and provide draining)
Perimeters: 3
Print orientation: Place the top of the soap mount against the build plate
Layer Height: .15 (higher layer heights work just fine, but layers become more visible)
Supports: NONE
Assembly Instructions
Add a strip of waterproof double sided tape to the back of the Soap Mount. The tape recommended below works well on glass, fiberglass, and tile.
Additional Parts Required
Waterproof Tape
- Amazon Link to 3M VHB Tape (https://a.co/d/aACaiWk)
Categories:
5 Likes1 DownloadsOctober 23, 2023