PS5 Horizontal Stand (for original disk version)
byNominal BrandHorizontal, minimalist, and subtle (unless you print it in bright red of course).
This design is for the original PS5 version with disk. Print 2 long springs and 2 short springs.
Print Recommendations
Print Material: PETG (this design relies on the semi flexible properties of PETG)
Infill Percent: 25%
Perimeters: 3
Layer Height: .3
Supports: NONE
Print orientation: Place each spring sideways against the build plate. Assembly Instructions
Attach double sided tape to each of the 4 springs. With the PS5 standing upright, place the 2 short springs near the base of the console (at each corner) and the 2 longer springs near the top.
Additional Parts Required Double Sided Tape Required
-
Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr
-
This adhesive twists off easily and doesn't leave residue.