Lens cap for Canon EOS EF and EF-S lenses
byNominal BrandThis model is restricted by licensing terms.
View license.
15 Likes37 DownloadsJune 25, 2024
This model is restricted by licensing terms.
View license.
Whether the dog chewed your lens cap or it fell off a cliff getting that perfect shot, the solution is one print away.
Print Recommendations:
Print Material: PLA
Infill Percent: 15%
Layer height: .15 (a layer height greater than .15 will not work since this model requires a very precise fit)
Orientation: Place the top of the cap down against the build plate
Supports: NONE
Category:
15 Likes37 DownloadsJune 25, 2024
This model is restricted by licensing terms.
View license.
15 Likes37 DownloadsJune 25, 2024
This model is restricted by licensing terms.
View license.