Free up your cabinet space with these pot lid holders.
Print Recommendations: Print Material: PLA Infill Percent: 20% Perimeters: 3 Layer Height: .2 (larger layer heights will work just fine but will be more noticeable) Supports: NONE Print Orientation: Place the holder on its side when printing.
Additional Parts Required: • 2 drywall screws (The screw holes on this mount have a 4mm diameter and can fit screw heads up to 9mm in diameter.) Make sure the screws are shorter than the cabinet width.
Category:
3 Likes2 DownloadsJuly 11, 2024