Floss at the ready.
Fits Glide Oral-B Floss
Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .15 Supports: NONE Print Orientation: Place the Floss holder standing upright on the build plate.
Additional Parts Required: • Double Sided Tape • Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)
Assembly: • Use a small amount of double sided tape to secure the floss mount to the wall.
Tip: You can create a wall mounted floss dispenser if you remove the floss lid (see last photo).
Category:
1 Likes1 DownloadsJune 28, 2024