By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
Print Recommendations:
Print Material: PLA
Infill Percent: 15%
Perimeters: 2
Layer Height: .15
Supports: NONE
Print Orientation: Place the Floss holder standing upright on the build plate.
Additional Parts Required:
• Double Sided Tape
• Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)
Assembly:
• Use a small amount of double sided tape to secure the floss mount to the wall.
Tip: You can create a wall mounted floss dispenser if you remove the floss lid (see last photo).
