2D3D
Makes
Be the first to upload a Make
0 Likes6 DownloadsJanuary 16, 2024
Craig200588's design was pretty good, but it wasn't going to fit my needs. So I widened the channels to 30mm and I cut it down a bit because i wanted it to be a little smaller and I carved out some of the center to lower the amount of filament.
I'm in the process of printing this up right now and will add results when I'm done.
Category:
0 Likes6 DownloadsJanuary 16, 2024
0 Likes6 DownloadsJanuary 16, 2024