A 360 magnetic locking spinner with Revolver and Turnstile like mechanics. Watch the videos to see it in action. If you print both spinners, only use 1 card for both.

Rules Trigger: Rotate spinner. Stop when zones are empty, if able. (If can't empty, stop spinning at magnetic lock as desired.)

Hardware

• seven M3x10 screws
• two 6x2mm magnets

Variations

• Duo Chamber Spinner
• Quad Chamber Spinner
• 1 part or 2 part cards available

Assembly

1. Glue two 6x2mm magnets into the sides of the spinner. Polarity doesn't matter. Wait until dried.
2. Install six M3x10 screws into the corners of the base.
3. Install a spinner with an M3x10 screw (or longer). It should freely spin, barely wobble and jitter when magnetically locking. If it's grinding on the base or not jittering, back out the corner screws a little.

This tile is part of my Mechanism Tiles Pack. Check the others out.

• Coin Flip https://than.gs/m/975594
• Gear Spinner https://than.gs/m/975606
• Lazy Susan https://than.gs/m/1249642
• Neo King https://than.gs/m/975604
• Relay https://than.gs/m/1327658
• Seesaw https://than.gs/m/975595