A tile that does a 180 degree spin. It switches between being a DIO and a OIC. Watch the video to see it in action.

Hardware

• one M3x10 screw (or longer)
• one M2x12 screw
• one M3 washer

Assembly

1. Install an M2x12 screw into the top of the flipper. It must protrude past the bottom of the flipper.
2. Insert an M3 screw into the flipper, stack a washer on the end of the screw, then install the flipper. It should freely spin and barely wobble. The M2 screw should not protrude past the bottom of the tile, should provide 180 degree rotational lock to the flipper and should not grind the wall of the base.

This tile is part of my Mechanical Flippers Pack. Check the others out.

• 180 https://than.gs/m/1116280
• Alternator https://than.gs/m/1116292
• Bounce Flop https://than.gs/m/1327656
• Follower https://than.gs/m/1228246
• I-Flop https://than.gs/m/1288093
• JL Flop https://than.gs/m/1327657
• Omni-Flip https://than.gs/m/1228247
• Side Flop https://than.gs/m/1116295
• T-Switch https://than.gs/m/1116307
• Trident https://than.gs/m/1228248
• Tri-Switch https://than.gs/m/1288137
• XC Flop https://than.gs/m/1327667