Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5156468.

This is a remix of the NanoMesh Mini and it also includes the proper top for the NVIDIA Jetson Nano 2GB Developer Kit (which uses USB instead of a barrel connector for power).

NanoMesh Mini is a compact case design for the Jetson Nano Developer Kit. This case be used entirely tool-less, although it can be secured with four case screws. The carrier board is held in place with stand-off pins. To secure the case together you can use 4 x m3 screws anywhere between 13-50mm long from the bottom of the case.

This case is designed to be printed entirely without supports and with no bridging.

The case can also support the optional external fan that mounts directly on the heat sink. The grill holes are just large enough to fit routing the 4-pin PWM cable.

I found that unless extremely careful, the pins on the stand-off posts just sheared right off when I pushed a bit on the board.