DA10 RawGuard (Definitely A 10)

Some cards look too pristine to settle for “probably.”

The DA10 RawGuard (Definitely A 10) is a magnetic toploader guard inspired by the elusive black-label grade—the hobby’s ultimate symbol of perfection. If you’ve ever heard someone insist, “It’s definitely a 10 bro,” before their raw card has even been graded, this display is for you.

Built around a standard toploader, the DA10 RawGuard gives raw cards the prestigious look of a black-label slab while making it obvious that it’s all in good fun. The bold black-and-gold design and custom “Definitely A 10” label instantly get the joke across and are guaranteed to start conversations at card shows, game rooms, shops, or anywhere collectors gather.

Like the original RawGuard, the magnetic two-piece design securely snaps around a standard toploader. Although the black-and-gold combination creates the classic black-label appearance, every part can be printed in different filament colors to personalize each build.

Commercial selling rights are available only to MysticMesh3D Authorized Merchants with an active Thangs subscription.

Features • Magnetic two-piece design • Compatible with standard trading card toploaders • Funny “Definitely A 10” parody slab design • Premium black-label-inspired appearance • Fully customizable with different filament colors • Premium display piece for raw cards • Great conversation starter for collectors and card shows • Quick and easy to print • Great for collectors, game rooms, card shops, and display cases

Printing Instructions

• Supports are required for the Front Plate.
• All other parts print without supports.
• Print each part in your preferred filament colors. Black and gold are recommended for the classic black-label appearance.

Assembly Instructions Each DA10 RawGuard requires:

• Eight (8) 5x2mm magnets
• Adhesive (CA glue or similar)

Step 1 Apply a small amount of adhesive inside each magnet pocket.

Step 2 Install all eight magnets, making sure the magnet polarity is correct before the adhesive cures.

Step 3 Apply adhesive to the back of the Label piece and attach it to the Label Border.

Step 4 Glue the completed Label Assembly onto the Front Plate.

Step 5 Allow all adhesive to fully cure.

Step 6 Snap both halves around a standard trading card toploader.

Required Hardware

• 8× 5x2mm magnets
• Adhesive (CA glue recommended)

Amazon purchase link for magnets (5x2mm): https://amzn.to/4vvnvUi