Side Quests [SQ2E1]

In this side quest I set out to make custom 3D printable glasses frames just in the nick of time.

Side Quest Episode

Full design session

| 3D Print Info | Materials: Rims - 3D Solutech See Through Orange TPU Stems - HATCHBOX Matte Black PLA - Amazon

Nozzle Diameter: 0.6mm - Amazon Layer Height: 0.15mm Temps: 210C Nozzle for PLA, 228C Nozzle for TPU, 70C Build Plate Wall Count: 5 Infill: None, use enough walls to make it solid Print Speed: 60 mm/s, 4 slower initial layers at 10 mm/s Build Plate Adhesion: 8 line brim Printer: ELEGOO Neptune 3 Max - Amazon

My printer has a custom hotend, here's what I used to build it: | Custom Hotend Supplies | Hardened Steel Nozzle - Amazon Copperhead C-E Bimetallic Heat Break - Amazon High Temperature Plated Copper Heater Block - Amazon Heater Block Silicone Cover - Amazon High Temp Thermistor - Amazon Metric Bolt Assortment - Amazon

| Tools Used | PRULDE Heat Gun - Amazon ValueMax Flush Wire Cutters - Amazon

| Affiliate disclaimer | Any affiliate links do not increase the cost of the item to you at all, and simply provide a small commission to me for my recommendation, should you decide to make a purchase using the link. If you aren’t comfortable with this, that’s totally ok, feel free to buy them without using my links. That’s how much I value my recommendations, I still stand by them even if they don’t benefit me at all. I only recommend things that I use for myself on a daily basis.

Stay Moxious