Enjoy a winged devil on a skull.
This is by far the most involved 3d printable model I have done to date. After the initial model was in place, it took over 20 printing attempts and a lot of model redesigns before I could reliably make it print in a SILK filament. In the end I was able to keep the wings spread out.
On my printer setup (Ender 3 V3 SE) and using SILK filament I could not get it to work with just the slicers Tree or Normal support, but had to also manually add support into the model, it is however easy to remove.
Attached pictures shows directly out of printer with the manual supports.
Attached are 3 versions
No supports please use slicers normal or tree support with 15% support threshold angle and it should work with normal PLA . Medium supports please ALSO use slicers tree support with 15% support threshold angle. Heavy supports please ALSO use slicers tree support with 15% support threshold angle. This prints reliably with SILK-PLA for me.