This is meant to be used on Ikea NOJIG 20x25cm organizers which have the tie bar clipped on and the smaller organizers inside.
It's a two-part design, which slides on from each end.
The parts are different sizes so that they align with the compartments inside
Each part is in its own STL file, and they are meant to be printed upright, without supports.
If you have issues with bed adhesion, I suggest you try using a brim or print the third file with both parts fused together with tabs you can cut off after.

Thanks to @credodenny on Thingiverse for the idea.

I might upload a variation which better fits the box without the tie bar and the smaller boxes inside



NOJIG 2-parter Lid

NOJIG 2-parter Lid (part A).stl

This prevents the deeper nojibg box from buckling when you stack shallower boxes on top for 2-level organizing.
They are super cheap, but the plastic is too flexible. The tie bar fixes that shortcoming.
Just clip it onto the edges of the big box.

There are a couple of tabs on either end which you need to cut off after printing - the are meant to keep the the first few layers of the clips in place so that you may print it without further support material.

Tie Bar for Ikea NOJIG

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Mivalys

Achievements

Seedling

Voyager

NOJIG 2-parter Lid

Tie Bar for Ikea NOJIG