Headless Horseman - Articulated Snap-Flex Fidget (Tight Joints)
byMimetics3D
Print-In-Place, No Supports, Articulating Fidget Toy
The Horseman rides throughout the night to fill the lonely streets with fright. Though during life he had a head, a pumpkin sits there now instead.
This Headless Horseman model is composed of 2 separate pieces. The Headless Horseman's Cloak and the Pumpkin Spine Snap-Flex Fidget.
This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.
Snap-Flex Collection: This articulated fidget toy integrates the Mimetics 3D "Snap-Flex" joint. This allows it to both move smoothly, mimicking the fluid motion of living creatures, AND stabilize in a firm pose, providing a premium fidgeting experience.
Each SNAP will resonate as a symphony of satisfaction to your ears, confirming your masterful manipulations.
Snap-Flex Instructions: To Lock: Push Body Segments together To Unlock: Pull Body Segments Apart
This Headless Horseman is the sixth creation in a series of Snap-Flex models by Mimetics 3D, and it's available for free for a limited time.
Tolerance: To accommodate different printer settings and filaments, I’m uploading 3 different tolerance levels for the Headless Horseman to ensure that you get the best fitting, most satisfying “SNAP” with each of your prints.
This is the Tight tolerance model. For the other tolerances, please check out the other versions of the model below:
Medium Tolerance Headless Horseman: https://than.gs/m/955580 Loose Tolerance Headless Horseman: https://than.gs/m/955581
Please try out each to see what works best for you, and let me know which version you prefer!
Other Models: The Headless Horseman's Cloak included in this model also fits the Skele-Spine found in the Grim Reaper model, so be sure to give your Headless Horseman a deathly friend:
Tight Tolerance Grim Reaper: https://than.gs/m/949070 Medium Tolerance Grim Reaper: https://than.gs/m/949068 Loose Tolerance Grim Reaper: https://than.gs/m/949066
Make sure to revisit us frequently for more thrilling Snap-Flex models to come. I'm eager to hear your feedback and collaborate on refining this model going forward.
This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.
Print Settings: 0.2mm Layer Height 3 Wall Loops 3 Top Shell Layers No Supports, Print-In-Place at 100% scale. Going any smaller may disable the Snap-Flex joint.
These tolerances are TIGHT and you'll likely have to snap each segment a few times before it's loose enough to snap/unsnap easily. I recommend you use regular PLA or PLA+. ABS might be even better, but I haven't tried it yet.
Silk PLA is a bit softer and may not click as nicely. I'd also be more concerned about silk PLA holding up to the wear and tear. If you print this in resin, please let me know how it turns out. I imagine you would need a more flexible/less stiff resin for it to work appropriately.