Arduino Module Tray x 3.stl
0 downloads · 3 years ago · Parts Tray:
This Module is used as just a parts tray to have loose parts while working on a project.
Parts Tray: This Module is used as just a parts tray to have loose parts while working on a project. I have added a file for 1 - 4 module slots in length.
Hardware needed: None
Instructions for Printing: Raft = no Brim = optional but not needed Wall Loops/Top and Bottom shells = 2 - 4 (personally i like 4 for extra stability) Layer Height = 0.2 mm Speed = Default Temperature = Default for your material of choice
During testing I used the Bambu Labs x1 Carbon with PolyLight PLA and left most settings in the Bambu Studio as default with any changes listed above so your print times may vary.
3 slots: Material = roughly 136 grams Time = 3 hours 40 minutes Material and time includes the Bambu X1 Carbon prep time and flow lines
Arduino Module Tray x 3.stl
0 downloads · 3 years ago in  andÂ
Hole Conector 4.stl
Arduino Module Peg.stl
Arduino Module Mega.stl
Arduino Module Uno.stl
Arduino Module Tray x 4.stl
Arduino Module Tray x 1.stl
Arduino Module Tray x 2.stl
Arduino Module Bread Board.stl
Arduino Module Mini Bread Board.stl
Key Conector 4.stl
Key Conector 3.stl
Key Conector 2.stl
Hole Conector 2.stl
Hole Conector 3.stl
_x_130(W)_x_32(H).png&w=3840&q=75)
Tray 210(L) x 130(W) x 32(H).SLDPRT
Cable Tray 450mm x 3000mm TYPE1
Cable Tray 150mm x 3000mm TYPE2
Cable Tray 50mm x 3000mm TYPE2
Cable Tray 50mm x 3000mm TYPE1
