This model is restricted by licensing terms.
View license.
14 Likes41 DownloadsJuly 12, 2024
This model is restricted by licensing terms.
View license.
Remix of the needle file holder by noxi to accommodate 6 files instead of 5. Moved up the snap connector so that there is a bigger surface on the bed, should stick better. Slightly fixed some geometry issues.
I needed 6 slots for my needle file set so i made this.
Printed in PLA+, 0.2 layer height, 15% infill, 3 walls.
To install you also need a regular multiboard snap.
Rubber hammer helps getting it installed ;)
Update 20/07/2024: Added an alternative version that supports larger/thicker files up to 6mm thick. The default is 4mm.
Remix of: https://www.printables.com/model/816210-needle-file-holder-for-multiboard
Categories:
14 Likes41 DownloadsJuly 12, 2024
This model is restricted by licensing terms.
View license.
14 Likes41 DownloadsJuly 12, 2024
This model is restricted by licensing terms.
View license.