AirTag Print-in-place.stl

This is an Apple AirTag holder that is print in place. No assembly required! It is designed using an AirTag model based upon Apple's dimensions of 31.9mm X 8mm and photos available since the announcement.

This has been successfully printed and tested using a 0.1mm layer height. A 0.15mm layer height should also work.

If you would like a more refined AirTag case, check out my AirTag KeyRing Twist-Lock Case on My Mini Factory here: https://www.myminifactory.com/object/3d-print-airtag-keyring-twist-lock-case-167136