Panthella Table Lamp It's so expensive so I decided to make my own!

https://youtube.com/shorts/9D8rlgBuxPs?feature=share

You will need - Small Edison E14 Socket & Lamp

I used this LED lamp https://www.jula.se/catalog/el-och-belysning/ljuskallor/led-lampor/paronlampor/paronlampa-led-019647/

this is my E14 cable setup https://www.jula.se/catalog/el-och-belysning/elinstallation/lamptillbehor/lamphallare/lampupphangning-410073/

To pull cable i use the thread with a needle!

Print Settings... Rafts: No Supports: No

Notes... Easy to print, No support No Raft needed

I premade G-codes works for any Ender-3 style 3D printers 0,2L.Height, 75mm/s, 8% infill, 200/50c - temperature settings you can change on the Go!

Enjoy & Happy 3D printing...