SET of 5 Tower Mazes - levels 11 to level 15 - optimized design

Mazetropolis

Remix Model

Social

Become a member

Makes

SET of 5 Tower Mazes - levels 11 to level 15 - optimized design 3d model

Here’s another batch of TowerMaze levels for you to enjoy if you are up for the challenge! Available for free until 8th of March so don’t hesitate to download and like them while they are available for free!

I listened to suggestions and therefore there are a few improvements. First of all the end part now has a “lock” at the end so that it stays closed once finished even if held upside down. And to save your material and print time, I made the mazes proportionally smaller - they are bigger than level 1 to 10 however they are way more detailed and the maze walls are only 60% of width of the previous models. Additionally, I increased the gap between the case and the maze as well as between the “hooks” and the maze for a smoother glide.

Below will be information about material requirements (amount of material per each level) as well as print times on specific print settings (might vary between different printers).

If you missed the first 10 levels, you can find them here

However, they are not available for free anymore. If you are interested in them, I would suggest becoming a member of my page as that will let you got way more designs and also commercial rights to sell the designs on your etsy shop as printed versions - all that for a price of 10$ a month (while the “Early bird offer” is available).

PRINT TIMES AND MATERIAL REQUIREMENTS (TOTALS AT THE END):

The case for the maze

Print Dimensions: Height =11.4 cm (4.49 Inches) | Diameter of 5.4 cm (2.13 inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 2 hours and 24 Minutes Amount of material required: ~ 20.3 m

Total Print time for 5 cases (1 for each maze): 12 Hours Amount of material required for 5 cases: ~ 101.5 m

LEVEL 11 MAZE:

Print Dimensions: Height =12.1 cm (4.76 Inches) | Diameter of 5.35 cm (2.11 inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 2 hours and 8 Minutes Amount of material required: ~ 17.6 m

LEVEL 12 MAZE:

LEVEL 13 MAZE:

LEVEL 14 MAZE:

LEVEL 15 MAZE:

Totals for 5 mazes + 1 case

TOTAL MATERIAM ALL MAZES: approximately 110 meters of material TOTAL PRINT TIME ALL MAZES: 13 hours and 7 minutes

Totals for 5 mazes + 5 cases

TOTAL MATERIAM ALL MAZES: approximately 190 meters of material TOTAL PRINT TIME ALL MAZES: 22 hours and 43 minutes