This model is a 3 part dice tower that you can extend upwards as much as you'd like with adding multiple mid sections. I've included 2 different base sections. The first has a smaller dice catch for more table room if you're only rolling a couple dice. The second has a large dice catch that will catch pretty much any amount of dice you can throw at it! Both base sections have a hidden hollow section for dice storage when not in use. Warning if you intend to permanently glue the tower together this storage will no longer be accessible.

Printing instructions:

• Should print without any supports included.
• Layer thickness 0.2mm and I slow down the print speed a tiny bit on the top section but this may not be required.
• I use an infill of 15% and seems to work just fine to be sturdy enough.
• I usually scale the model down a bit because I designed it quite large. 90% of the original scale is what I’ve done but I think you could push that a bit more as well if it's too large for you.