Mike H
Maple 3D Printing3.8K followers
Follow
Maple 3D Printing
Maple 3D Printing
|
Image 1 of 5
Snap Shut Deck Box - Window Version 3d model
Maple 3D Printing
Maple 3D Printing
|
Image 1 of 5
Snap Shut Deck Box - Window Version 3d model
Snap Shut Deck Box - Window Version 3d model
Snap Shut Deck Box - Window Version 3d model
Snap Shut Deck Box - Window Version 3d model
Snap Shut Deck Box - Window Version 3d model
Snap Shut Deck Box - Window Version 3d model

Snap Shut Deck Box - Window Version

Subscribe for access starting at $11 USD
Get access to this model and 454+ more

This is the Snap Shut Deck Box, Window version. It holds either 100 cards double sleeved or 60 cards plus the Accessory Box inside. Use the Accessory box to carry all of your dice, coins, and tokens that you would need for your game of choice. This box is perfect for any of your favourite TCGs like Pokemon, Magic the Gathering, One Piece, YuGiOh, Digimon, Dragon Ball, or whatever else you may want to use it for! The window will hold a standard top loader to show off your favourite card or Leader/Commander.

This whole set can be printed without supports if your bridging is good, otherwise a little support on the lid may be needed where the clips slide in. Make sure to print the clips on their side so you get the most strength out of them and then just slide them into the bottom piece.

Go check out the other versions available including the Basic version if you want to test out the design or try out the Stylized versions too!


Discussions

Snap Shut Deck Box - Window Version

73 downloads · 10 months ago in 
Mike H
Maple 3D Printing3.8K followers
Follow
Subscribe for access starting at $11 USD
Get access to this model and 454+ more