Let there be LIGHT!!
The inside of the Bambu X-1 is best described as "A Cave". The stock LED lightbar just does not put enough light into the printer's chamber. This add-on is 3D Printable riser for the glass top that allows installation of an LED light strip. With a good light strip you can finally SEE YOUR PRINTS!
This is a remix of a multi-piece design with some geometry repairs. It is a LARGE print that will require a big printer. Measures 387mm x 356mm, ensure your build volume can fit it! I used the Elegoo Neptune 3 Max
Remixed from this design: https://www.printables.com/model/365027-bambulab-top-glass-riser-4-cob-led-remix-with-led-
Parts Needed (Affiliate Links):
- 1x - LED Light Strip: https://amzn.to/3JzJx2K
- 1x - 24v PSU: https://amzn.to/3JzxOAU
- Elegoo Neptune 3 Max: https://tinyurl.com/Neptune3Max
- Polymaker Filament: https://tinyurl.com/Polymakerr
Files Included:
- One Piece LED Riser - STEP File
- One Piece LED Riser - Left Wire Exit
- One Piece LED Riser - Right Wire Exit
- One Piece LED Riser - Both Exits
- 4x TPU Gaskets
Recommended Print Settings:
- 3 Perimeters
- 10% Infill
- No Supports Required
- PETG or higher temp material recommended. Chamber temps can get over 50C and may be too high for PLA.
- TPU recommended for "gasket" prints to seal the glass to the print. Softer the better.
Want to Support what I do? Check out my social medias please!
Link Tree: http://www.MandicReally.com/links