Pineapple Springo (Half Size)

Relevant Video

Pineapple springo? Say no more...

This is the half-scale version of my Pineapple Springo, part of the Tasty Springos Pack which you can check out here.

I got the best results printing with 3 outlines/shells, 0.15mm layer height, and enough solid top & bottom layers to make the spring part solid infill. No supports required.

After printing, carefully separate the coil using a thin spatula, palette knife, butter knife, etc. Work slowly and with caution, especially if you are using sharp tools!

Springos pictured were printed using MatterHackers PRO PLA (Clear, Blonde, Green) and Fillamentum Vertigo Galaxy PLA