OP-1 BestCase Decksaver and Stand // Waveform (multipass multicolor)

Protect your OP-1 in the coolest way possible with a decked out cases! The OP-1 BestCase is both a deck protector and a stand that tilts the OP-1 up to take advantage of the same ergonomic benefits that computer keyboards have been rocking since the 80's.

This Waveform version uses single extruder multipass printing for up to 5 colors on the first layers of the print! You can learn more about the technique here . Of course, if you have a multimaterial printer, that works too!

To get the 2 color graphics, swap filament at 0.4mm layer height. This can be achieved with pause at layer height plugins for Cura, Octoprint, etc, or by slicing two separate models, one that stops at 0.4mm and the next starting at 0.4mm. Some printers have a built in pause at layer height feature.

The model includes round tabs at each corner to improve build plate adhesion. They can be ripped off afterward, or cleanly removed with a X-acto knife.

As you're likely aware, PLA is not sun-friendly, so avoid exposing a PLA case to warm environments to prevent warping. If you want extra security, I recommend silicone bands like these Grifiti Bands (also on eBay) or these.