This thin and simple form complements the delicacy and organicity of a small dried plant that can be displayed in the center, creating an art piece for your home that incorporates nature while being maintenance-free and long lasting.
The small indent in the center creates an illusion of the plant stem warping the surface, as well as resembling the point of a fruit where the stem meets the body.
Fovea has a 1.6mm hole for your plant (or incense stick, feather, etc...), and each side is 50mm wide.
Printing Guide
This model prints on its side and requires no supports. Depending on your bed adhesion, you may want a decent brim. Your default print settings should work fine! I used 0.16mm layer height, and the pictured model uses the 'Fuzzy Skin' setting with 'point distance' of 0.3mm and 'skin thickness' of 0.3mm (this does slightly decrease the size of the inner hole).
Photographed model was printed using Fillamentum Extrafill PLA Traffic White also available at 3DJake and MatterHackers. Printer was the QIDI Q1-Pro 3D Printer*
These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!.