Clover // Flatland Keychain Magnet
Bring good luck wherever you go with this little clover keychain. This charm has a secret compartment with a snap on lid. Inside you can place magnets, an NFC tag, or a lock of unicorn hair.
Printing Guidelines
0.16mm layer height, print solid.
The inner compartment is 20mm diameter and 3.6mm tall. I just put three 3x6mm magnets in loosely for hanging on a magnet strip. The snap on lid should be a nice tight fit that doesn't require glue, but if you were to scale up the model and throw an airtag inside--for example--you might want to glue everything together with E6000 or another adhesive.
Keychain holes are designed for a jump ring of roughly 9-10mm diameter, as common with keyrings in bulk (on Amazon).
Photographed models were printed on the Bambu Lab X1-Carbon 3D Printer using Bambu Lab PLA Matte Grass Green.
*These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!
Clover // Flatland Keychain Magnet
EZPZ Screwdriver Bit Clip
IKEA FLISAT Bench TPU Feet // Floor Protector + Grip
EZPZ Pot Spacers // Airflow and Drainage for Plants
EZPZ TPU Cable Clip Collection // Quick, Flexible, Cable Clips
EZPZ Dummy Nail // Damage Free Wall Hanger Collection
EZPZ Wall Hooks Collection // 17 Variations (and counting!)
EZPZ Shelf Hook Collection // Type 1
EZPZ TPU Cable Clip (4mm)
Caliper Undercut Gauge Adaptors
EZPZ Wall Hook // Type A 36mm
EZPZ Small Shelf Hook // Type1
EZPZ Tube to Wall Mount
Moss Dish/Frame for 100mm Chunky Puck Drip Tray
IKEA Bekväm TPU Feet // Floor Protector + Grip
Sink Brush Hanger // TPU Brush Loop Kitchen Organizer
SHIMMER 03 Planter
SHIMMER 02 Planter
SHIMMER 01 Planter
EZPZ PS5 Controller Wall Mount
