I'm not good at painting so my goal with this "Cartoon Rocket" was to design something that didn't required paint while still looking great. I only used standard Cura settings in order to make it easier to print this model.
All the parts have been orientated the same way as I printed them, everything was printed on my ender 3 pro and I used CA glue to put everything together. Some cleaning of the parts printed with a brim was required, also the window has a thin edge that goes facing down and the window rivets sometimes will break of from the base so you either mount it with the base if the don't brake or just glue each rivet directly to the window.
The rocket is 15cm tall by itself and 22cm tall with the base
3D PRINTING SETTINGS Red parts: Nose x1: Standard Quality 0.2mm setting, no supports Window x2: Standard Quality 0.2mm setting, no supports Fins x1: Standard Quality 0.2mm setting, brim and no supports
Gray parts: Body rivet x12: Standard Quality 0.2mm setting, brim and no supports Side panel x2: Standard Quality 0.2mm setting, brim and no supports Window rivets x2: Dynamic Quality 0.16mm setting, brim and no supports Nozzle x1: Standard Quality 0.2mm setting, brim and no supports
White parts: Body x1: Standard Quality 0.2mm setting, no supports Smoke x1: Standard Quality 0.2mm setting, no supports
Black parts: Tile left x2: Standard Quality 0.2mm setting, brim and no supports Tile top x4: Standard Quality 0.2mm setting, brim and no supports Tile right x2: Standard Quality 0.2mm setting, brim and no supports Tile bottom x6: Standard Quality 0.2mm setting, brim and no supports