By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
An inverted version of the test tube propagation mount.
3 different versions:
Small (screw mounted)
Full length (screw mounted)
Full length (command strip mounted)
Supports
None needed!
Scaling
I wouldn't recommend scaling this one since it perfectly fits the test tube, the screw holes are designed specifically for #8-10 x 1 in anchors and screws, and the command strip mount is the exact size of a regular large command strip.
Orientation
The mounts should be upside down and the cleat should have the longer side facing down.
Print Settings
.2mm layer height
15% grid infill
2 walls
Monotonic top and bottom surface pattern
Filament & Hardware
Filament I used for this print: Hatchbox Matte Ash Gray PLA
Overture Matte Light Brown PLA
Test tubes
Hardware: #8-10 x 1 in anchors and screws
Command Large Refill Adhesive Strips
Filament and hardware/non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://hendricks.design/links/