Remixed [this tooth brush holder](https://www.thingiverse.com/thing:3085386) and [this tooth model](https://www.thingiverse.com/thing:4245420)

Designed to be attached to the wall using silicone caulking (Use the high-tack type) or using double sided tape (3M VHB or similar is recommended).

Tooth shaped toothbrush holder for Oral B

Remixed [this tooth brush holder](https://www.thingiverse.com/thing:3085386) and [this tooth model](https://www.thingiverse.com/thing:4245420)

Tooth shaped toothbrush holder (oral B)

We bought a large tub for our kid, but it didn't have a drain.
_3D printer to the rescue!_

**Printing directions:**
For hygiene, all parts should be watertight. Suggestions:
1. Print with a large amount of walls (side and top/bottom)
2. Overextrude using extrusion multiplier
3. Seal the print later (I used ABS slurry to seal mine).

**Additional required parts:**
1. [silicone toilet flush seal](https://duckduckgo.com/?q=flush+valve+seal+7381042-0070A&atb=v1-1&iar=images&iax=images&ia=images) with a ~25mm (1") ID
2. Some sort of water tight glue to adhere the threaded part to the tub (Silicone caulking recommended)
3. 25mm drill (usually a step drill) to drill through the tub (or a sharp and hot knife to through the tub).

**To install:**
1. Drill a ~25mm through the tub
2. On the male thread: place a modest amount of silicone caulking on the top surface of the large disc
3. insert the threaded part through the hole from the bottom (caulking should now be sandwiched between threaded part and tub bottom
4. Wipe away any excess on the inside of the tub and the outside.
5. Let the caulking set per the manufacturer's directions
6. Place a [silicone toilet flush seal](https://duckduckgo.com/?q=flush+valve+seal+7381042-0070A&atb=v1-1&iar=images&iax=images&ia=images) on the threaded part from the inside
7. Thread nut onto the thread, when tightened it should sandwich the silicone seal and create a tight seal
8. To let water out, partially loosen the nut

Drain plug for wash tub (threaded)

Threaded plug for for kid's wash tub

Tub screw v2.par

Tub nut v2.par

Poo Emoji (AKA Poop Emoji)

Poo.stl

Fun little model made as a gag gift for a friend.

Suggested to print body and stopper end separately and glue them later.

If using SuperSlicer or similar (Slic3r, PrusaSlicer) I suggest setting the parameter [Infill > Advanced > Anchor solid infill by X mm] to something ridiculous like 1000mm in order to ensure the large layers anchor to the sides.

Poo emoji toilet paper holder

Full model, not recommended you attempt to print this directly

PooTPHolder.stl

PooTPHolder.stp

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Leav

Achievements

Seedling

Tooth shaped toothbrush holder for Oral B

Drain plug for wash tub (threaded)

Poo Emoji (AKA Poop Emoji)

Poo emoji toilet paper holder