AnkerMake M5C square build plate guides

The build plate guides provided with the M5 are great, but I wanted to use a smooth PEI plate. With this in mind, print two replacement guides using ASA or ABS, as they are durable materials. No supports are needed. 

It's worth mentioning that the build surface dimensions perfectly match those of the Ender 3.

Alternate AnkerMake M5C Filament Guide

I ran the printer for a while without the filament guide, and when retracting, it made the spool bounce around a little more than I was comfortable with. I built this as an alternative to the top guide provided with the printer. You can print this guide with PLA or any other filament and with no supports needed. Reuse the clips from the guide provided with the printer sliding the tubing from the top toward the build plate.

bltouch cover right reverse mount

remix of https://www.thingiverse.com/thing:4634422 the screws did not work for me so I added a "finger" at the top so it just slides on also did it in a mirror version for a right side vs left side mount. For the Elegoo Neptune 2 and dual fan duct I use (https://www.thingiverse.com/thing:4949488/files). 

Screen stylus (remix)

I have a small touchscreen and am using Marlin 2.x. The screen I have is not very responsive and found a stylus works pretty well (https://www.thingiverse.com/thing:4493887/filesl. I downloaded the stylus then made a mount that slides into the rail. 

ezio-auditore-REMIX.3mf

remix of https://www.thingiverse.com/thing:4098773

- I cleaned up and solidified the base.
- Significantly reduced the polygon count as it was way too high.
- corrected bad meshes.
- increased height to 250 mm (you can print smaller if you want. 

NOTE: I recommend this only for personal use based on my understanding of how the original was acquired. 



Lazy Beagle

Achievements

Seedling

Voyager

Fan Favorite

ezio-auditore-REMIX.3mf

AnkerMake M5C square build plate guides

Alternate AnkerMake M5C Filament Guide

bltouch cover right reverse mount

Screen stylus (remix)