😺Cat Pixie 😺

• 3 walls, 15% gyroid or 3D honeycomb infill. No supports.

• Tested down to 50% and up to 150%. I don't recommend going below 100%

• I recommend printing the pixies with 0.16 Layer height or smaller.

Editing 3MF

• Avoid using the slicer's fill tool when coloring the eyes, eye shine, and snout in the 3MF files, because they are split to parts. Instead, assign color to them from the object list to make the edges look cleaner. Do not split to objects. 



• The eye shines can be deleted by holding ALT on your keyboard and clicking on them in prepare tab, then right clicking and choosing delete from the drop down.

• Please note that 3MFs will load with a custom profile that I used to print these models. Double check your settings prior to printing.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐
 + + 📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available from my profile page - Click here📌