LaserPecker LP5 Guard Blank

This part fits under the LP5 where the safety guard usually goes.

You will require two m4 screws of 15mm to attach this to the LP5 You will also require a magnet. I used 3mm x 2mm high magnets to design this, so they will glue into the circular indentation just fine. (See green circled area in image)

Safety Note, "PLEASE DO NOT IGNORE THIS"!!! This part replaces the safety guard that MUST be used when using the engraver, if you use this part because you need to use the rotary/slide extension or the part you are engraving, the guard gets in the way. WEAR YOUR SAFETY GLASSES THAT CAME WITH YOUR LP5!!!

I made this to overcome issues the guard caused, NOT to bypass safety. Looking at laser light, can and will, blind you and at no time, if you use this without appropriate protective eyewear, can I be held accountable for your ignorance of this warning!!! Your eye sight and SAFETY is your resposibility, not mine, you have been warned

Your safety guard still needs to be plugged in to the usb port, even if you use this part.