tracking pixel
Khalm Down H

Desk Organiser (Organizer)

by
Khalm Down Hobbies
Follow
Follow
Remix Model
Khalm Down Hobbies
Khalm Down Hobbies
|
Image 2 of 5
Desk Organiser (Organizer)  3d model
Khalm Down Hobbies
Khalm Down Hobbies
|
Image 2 of 5
Desk Organiser (Organizer)  3d model
2D
3D
Makes
Desk Organiser (Organizer)  3d model
Desk Organiser (Organizer)  3d model
Desk Organiser (Organizer)  3d model
Desk Organiser (Organizer)  3d model
Desk Organiser (Organizer)  3d model
This model is restricted by licensing terms. 

This is a simple desk organiser or organizer for the Americans. It ties a few key designs together along with a spot for my pencil sharpener (The one used in the images was not the original thus the jank mod) a rubber (eraser for the Americans) and a Norris Math set which is a common instrument set here in Australia. This is cut into 2 pieces marked left and right as well as a whole if you have a large enough bed. Externally printed parts that make this up are: Pen Holder originally uploaded @ https://www.crealitycloud.com/model-detail/652e5a6206d6cf3ae6afd1b0 The Micro/SD/USB Rotating Organiser (Organizer) are from https://www.thingiverse.com/thing:4874570 by Texas_In_FPV with a massive shout out for a favourite design of mine and one of the first things I printed that needed bearings. These need 2x 608zz each to rotate. (Side note my wife and I constantly refer to these as the USB Darlek’s from Doctor Who. To glue the 2 halves together in my case as I’ve printed V1.0 I had a soldering iron to make some clearance, so I just did a plastic weld. Otherwise, I would use superglue or another preferred glue option. Printed easily in imported orientation and I’ve done mine in a part roll of PLA and a bit more of another roll in PLA. Printed on the Creality K1 Normal Profile at 3x3 at 10% infill.

Revisions: V1.0 – Initial Sketch, design and prototype completed, printed as 2 halves, and found some clearances were insufficient. V1.1 – Added 0.4mm onto 2 of the tight clearances with good results & remodelled the sharpener position around the sharpener I've used.


1 Likes3 DownloadsOctober 22, 2023



1 Likes3 DownloadsOctober 22, 2023
This model is restricted by licensing terms.