Khalm Down H

Anycubic Kobra Proximity Sensor (Probe) Replacement bracket

by
Khalm Down Hobbies
Follow
Follow
Remix Model
Khalm Down Hobbies
Khalm Down Hobbies
|
Image 1 of 17
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Khalm Down Hobbies
Khalm Down Hobbies
|
Image 1 of 17
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
2D
3D
Makes
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
Anycubic Kobra Proximity Sensor (Probe) Replacement bracket  3d model
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:6135378.

This was a simple part I did up during the process of repairing a Kobra that I ended up with, after updating the cooling I found that I didn't have a Proximity sensor anymore. In my case I ordered a LJ12A3-4-Z/AX from Ali and installed it. After verifying it worked with a Zip tie this was the result.

2x M3 x 8mm to mount into original plate. Adjustable up and down simply using nuts to hold into correct height. Printable upright or lying down, in my case I had the block down and just cleaned up the little stringing from the overhang. No support required that way. I have done this in PLA+ but recommend PETG if PLA starts to deform although it shouldn't thanks to fan proximity. End of arm sits tight against Blower upgrade you can see.


0 Likes3 DownloadsJuly 22, 2023


0 Likes3 DownloadsJuly 22, 2023
This model is restricted by licensing terms.