tracking pixel
James D

Halloween Keychain Mega Pack x50

by
Keuros Designs
Follow
Follow
Remix Model
Keuros Designs
Keuros Designs
|
Image 1 of 3
Halloween Keychain Mega Pack x50 3d model
Keuros Designs
Keuros Designs
|
Image 1 of 3
Halloween Keychain Mega Pack x50 3d model
2D
3D
Makes
Halloween Keychain Mega Pack x50 3d model
Halloween Keychain Mega Pack x50 3d model
Halloween Keychain Mega Pack x50 3d model
This model is restricted by licensing terms. 

Enjoy my mega pack of 50 Halloween keychains!

Test printed every one of them after giving them a dash of colour in Bambu Studio.

I printer using a .4mm nozzle at .2mm layer height. The details are pronounced so you can do a manual colour swap after 3mm to get all the details in a separate colour if not using an AMS system.

3D printing settings .4 nozzle or .2 for extra crisp details .2 layer height 10-15% infill Arachne for wall generation is a must if using .4 nozzle! Brim to avoid corners lifting when printing full plates


0 Likes0 DownloadsSeptember 23, 2024


0 Likes0 DownloadsSeptember 23, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA+
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimYes