tracking pixel
Kazi T

Benchmark Bot

by
Kazi Toad
Follow
Follow
Remix Model
Kazi Toad
Kazi Toad
|
Image 2 of 14
Benchmark Bot 3d model
Kazi Toad
Kazi Toad
|
Image 2 of 14
Benchmark Bot 3d model
2D
3D
Makes
Benchmark Bot 3d model
Benchmark Bot 3d model
Benchmark Bot 3d model
Benchmark Bot 3d model
Benchmark Bot 3d model
Benchmark Bot 3d model
Benchmark Bot - My son looooves it, already started number 2!
Weakest are the little gear on the back, one already popped off but it's fine anyway. - 3d model
Benchmark Bot 3d model
Benchmark Bot - Came out grate after a little bed temp tweaking. - 3d model
Benchmark Bot - PolyLite Red - 3d model
Benchmark Bot - First try with suggested settings on an Ender 3 Pro. All joints work. One hip joint was tight, but then broke free and works fine. This is a great model. Thank you for sharing it. I'm printing the accessories now :-) - 3d model
Benchmark Bot - Red color printed with Bambu Lab X1 Carbon Combo 3D printer and Polyterra PLA.

Yellow color printer with Flsun V400 3D printer and PLA+ filament.


All No brim, No support and 350mm/s

Bye.
Tony - Italy
 - 3d model
Benchmark Bot 3d model
Benchmark Bot - 100% Benchmark Bot
150% Benchmark Bot - 3d model
This model is restricted by licensing terms. 

These files are for Personal Use Only. If you would like a Commercial License to sell prints made from these designs, please join me on Patreon: https://www.patreon.com/kazitoad

Move over boat, there is a new benchmark in town.

This robot is not only a fun print-in-place figure but it is also a very useful calibration tool.

The robot is designed with 17 functional joints with different orientations, couplings, and tolerances. The tolerances range from 0.2 - 0.5mm and allow you to test the minimum clearances your printer can produce and still achieve print-in-place movement.

Each limb is labeled with the tolerances of their joints and all other joints have a 0.3mm tolerance. It might take a little (just a little) bit of force to break them free any more and you risk breaking the robot.

It only uses 20g of filament and is small enough to fit on a Prusa mini or even a Voron V0.

To add to the #MakerMadness theme I have added some accessory, because what says "spring" more than a robot wearing sunglasses and holding a flower 😁.

Link to the Rock version: https://thangs.com/mythangs/file/55887

Print Settings:

No support! No brim!

The point of the Benchmark Bot is to find the best parameters to make it function, therefore it is difficult to recommend any settings.

That being said, I used the following parameters: 0.4mm nozzle, 0.2mm layer height, PLA, 3 walls, 4 top/bottom layers, 10% infill.


647 Likes2.9K DownloadsMarch 10, 2022


647 Likes2.9K DownloadsMarch 10, 2022
This model is restricted by licensing terms.