Move your drawers from under your desk, workbench, or enclosure and place them in an even more convenient location on you the wall using an IKEA Skadis peg board!

WHAT YOU'LL NEED

• Ikea Skadis Pegboard (I didn't have one so I printed my own) • GEN2 small drawer case with Quick Release Mechanism (currently under GEN2 prototyping) • GEN2 small drawer or tilt drawer • (x2) M3x12 screws • (x2) M3 nuts

INSTRUCTIONS

Print the rail and the 2 side brackets

Prep the 2 side brackets by pulling an M3 nut, using an M3 screw, into the slot under the rail

Install the side brackets onto the SKADIS board, there is a left and right side (the rail on top should have a flat side which is what you want facing inward towards where the drawer will go) For single unit bracket you will place them 4 pegs apart.

Slide the rail unit onto the top of the side brackets.

Use an M3x12 or longer screw and lock the rail unit in place.

You can now slide a GEN2 small case with quick locking into place.

Congratulations! you have successfully completed installing this thing. Now you can snap more small drawers below.

OPTIONAL Attach a Gridfinity grid on top of this model! GEN2 Skadis Mount Gridfinity Add-on