A great way to clean up your cables on your Bambu A1!

Contents:

• TOP BAR ELASTIC MOUNT
• Z AXIS CABLE CLIP (for AMS Lite cable) - I print two of these

Additional things needed:

• Double-sided tape/mounting pads x2
• 3mm diameter elastic cord (or smaller)

Steps to install Top Bar Elastic Clip:

1. Tie elastic cord in a loop of approx 2cm (3/4 inch) diameter around the extruder cable
2. Thread the clip into the elastic loop
3. (optional) For a clean look try to keep the knot hidden in the space inside the clip
4. Lightly flex the clip over the top bar approximately 1/3 from the right-hand side of the bar
5. Check cable doesn't stretch too much when homing the printer head - if it looks tight, make the loop of elastic bigger :)

Z-Axis Cable Clip:

1. Cut double sided tape to size of back of clip(s) and stick on
2. Stick clips on back of Z-axis columns
3. Insert cable into clips :)