Reconstructed Can Holder(IJF) v10_ascii.stl

Buddy has a Sea Doo Spark that is missing a cupholder, so I took a stab at making an adjustable one. To assemble you will need 4 washers that are 0.5mm thick with a 5mm diameter hole. (Alternatively you can use 2 1mm washers but with a little more friction.) Additionally you will need a length of 4mm wire approximately 205mm in length or appropriate length pins. At the center of the wire you will mark approx. 5mm on either side. Bend at 5mm marks until right angle is formed, repeat process on other mark in same direction to form a U shape. Feed the U through the top of the Top Left and Top Right pieces, add washers, add bottom and bend exposed ends on the bottom to keep assembly together. 4mm holes are on the back of the Top Left and Top Right, which are for a little bit of bungie cord in a crisscross pattern to keep the rear closed and adjustable. For mounting Use Mount Plate and the main assembly has the equivalent of a M8 x 1.25.

Bottom Rebuilt_ascii.stl

Top Left Rebuilt_ascii(IJF).stl

Top Right Rebuilt_ascii(IJF).stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

Jakk Von Swaggr

Achievements

Seedling

Reconstructed Can Holder(IJF) v10_ascii.stl

Bottom Rebuilt_ascii.stl

Top Left Rebuilt_ascii(IJF).stl

Top Right Rebuilt_ascii(IJF).stl