tracking pixel
Ian_Smalley

Storm Trooper Clock V1

by
Ian_Smalley
Follow
Follow
Remix Model
Ian_Smalley
Ian_Smalley
|
Image 2 of 3
Storm Trooper Clock V1 3d model
Ian_Smalley
Ian_Smalley
|
Image 2 of 3
Storm Trooper Clock V1 3d model
2D
3D
Makes
Storm Trooper Clock V1 3d model
Storm Trooper Clock V1 3d model
Storm Trooper Clock V1 3d model

5 Colour Storm Trooper clock, made using Bambu filaments.

(I recommend the following max speed settings, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Marine Blue Transmission Distance: 2 PLA Bambu PLA Basic Red Transmission Distance: 5 PLA Bambu PLA Basic Yellow Transmission Distance: 3 PLA Bambu PLA Matte Ivory White Transmission Distance: 4

Swap Instructions: Start with Charcoal At layer #5 (0.4mm) swap to Marine Blue At layer #6 (0.44mm) swap to Red At layer #16 (0.84mm) swap to Yellow At layer #19 (0.96mm) swap to Ivory White for the rest.

(clock - border with numbers)

At layer #31 (1.44mm) swap to choice of colour for border

At layer #39 (1.76mm) swap to choice of colour for numbers

(clock - border with number markers)

At layer #31 (1.44mm) swap to choice of colour for number markers

At layer #39 (1.76mm) swap to choice of colour for border

(clock-plain with border)

At layer #31 (1.44mm) swap to choice of colour for border

I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

The Model is designed to print with 0.4 nozzle.

If re-scaling model make sure not to alter the Z height of the model

add a negative cylinder to the Centre of the clock in the slicer to create the correct size hole for your movement or alternatively drill the required size hole.

Link for the movement that I used is listed below but any standard movement will be fine (be sure to check the size of the hands)

https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details

ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.


7 Likes14 DownloadsSeptember 17, 2023


7 Likes14 DownloadsSeptember 17, 2023