6 Color HueForge model. Spitfire filament painting made using Bambu Pla Basic filaments.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
(I recommend the following speed settings for the Bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Filaments Used: PLA Bambu PLA Basic Black Transmission Distance: 0.6 PLA Bambu PLA Basic Blue Gray Transmission Distance: 3 PLA Bambu PLA Basic Brown Transmission Distance: 2 PLA Bambu PLA Basic Orange Transmission Distance: 10 PLA Bambu PLA Basic Yellow Transmission Distance: 6 PLA Bambu PLA Basic Jade White Transmission Distance: 5
Swap Instructions: Start with Black At layer #12 (0.6mm) swap to Blue Gray At layer #17 (0.8mm) swap to Brown At layer #19 (0.88mm) swap to Orange At layer #21 (0.96mm) swap to Yellow At layer #23 (1.04mm) swap to Jade White for the rest.
This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results.
Use the exact numbers in your slicer to match up properly.
Two different size models are supplied and designed to print with 0.4 nozzle
If Scaling the model make sure not to adjust the Z-Height of the model
ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.