Incredible Hulk Clock (Filament Painting)

5 Color HueForge model. 'Incredible Hulk Clock' filament painting made using Bambu filaments.

if you are not familiar with printing at really fine layers such as 0.04 you will need to lower the print speed on printers like the bambu

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Filaments Used: PLA Bambu PLA Basic Black Transmission Distance: 0.6 PLA Bambu PLA Basic Green Transmission Distance: 2 PLA Bambu PLA Basic Bambu Green Transmission Distance: 6 PLA Bambu PLA Basic Yellow Transmission Distance: 5 PLA Bambu PLA Basic Jade White Transmission Distance: 5

Swap Instructions: Start with Black At layer #14 (0.68mm) swap to Green At layer #15 (0.72mm) swap to Bambu Green At layer #16 (0.76mm) swap to Yellow At layer #25 (1.12mm) swap to Jade White

At layer #33 (1.44mm) swap to Black for the rest (or the colour you would like for the frame)

for the clock with numbers-

At layer #44 (2.04mm) swap to white for the rest (or the colour you would like for the numbers)

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

The Model is designed to print with 0.4 nozzle.

If re-scaling model make sure not to alter the Z height of the model

ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.

Add a negative cylinder to the Centre of the model in slicer to create the correct size hole for your movement or alternatively mark the Centre at the rear and drill the required size hole.

Link for the movement that I used is listed below but any standard movement will be fine (be sure to check the size of the hands)

https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details