Stand for IK3D Heads / No Supports

Now you can display your favorite heads without needing to drill any holes on your walls, and it's also an easy but elegant way to display the heads on markets too.

This is the first version of the stand for my heads. Quick and easy to print, no supports needed!

All you will need is a couple of small screws to fit on the grid (The holes on the grid are 2.3mm diameter x 5mm deep) and your favorite IK3D head.

It works with the following models at 100% scale: Dinosaur Heads (T-rex, Raptor and Brachiosaurus), Balrog head and Wolf. It will fit others too when scaled down.

"The model included is the stand you can see in the third picture, the Raptor or Alien heads are not included here, but you can find them in my store."

"All of my models are for personal use only, unless you are an active subscriber of Thangs with a commercial license."

3D PRINTING SETTINGS:

-No supports needed -2-3 Walls, 0.2-0.24mm layer height (Adjustable layer height is recommended), 10-15% infill -Use small screws of 3mm diameter and 10mm long