Perfectly Print-in-place No Support Needed
A tentacle, a cone, and a banana. It's hilarious and absurd, and I love it!
No glue is involved, and you only have to screw the tentacle in.
Go print this masterpiece of weirdness!
Super easy to print! Great gift 🤍
3D PRINTING SETTINGS To get the best out of the STL file, please follow these guidelines:
• No support is needed. Everything is ready for printing. • Layer Height 0.2mm • Nozzle 0.4mm • Recommended infill 15%. • Recommended Infill Pattern: Gyroid.
• Prepare and clean your bed for excellent adhesion. • Make sure your bed is correctly leveled. Then check again :D • Try to hide the seam and place it behind where nobody will pay attention. • Make sure your printing and bed temperatures are adequate for the filament you are about to use.