There are other variants in my profile. Go check them out! Print-in-place No Support Needed
What an adorable little box for your desk! Be creative and use any kind of color. Super easy to print and assemble! Great gift 🤍 Guarantee 100% cute & Kawaii! (✿◠‿◠)
Use a little point of super glue to assemble the elements. (What I am using: BSI Insta-Cure+)
Please, tag me on Instagram or TikTok (@holoprops); I would be thrilled to see your prints!
To get the best out of the STL file, please follow these guidelines:
• No support is needed for any parts. Everything is ready for printing. • Layer Height 0.2mm • Nozzle 0.4mm • Recommended infill 15%. • Recommended Infill Pattern: Gyroid or Cubic • Avoid any Elephant Foot or the box will not close properly.
• Prepare and clean your bed for excellent adhesion. • Make sure your bed is correctly leveled. Then check again :D • Try to hide the seam and place it where nobody will pay attention. • Make sure your printing temperatures and bed temperatures are adequate for the filament you are about to use.