An oversized Push-Pin for an oversized pegboard. This plus-sized push-pin is a bit of novelty and function for hanging heavy stuff on pegs. It keeps heavy things like backpacks from accidentally sliding off the standard pegs.
Printing This should print fine without support so long as you can handle 60 degrees of overhang. if you run into any trouble try expanding your line width up to around 0.8mm.
With a 4-inch x 3/4 dowel up inside this model, it can hold quite a lot of weight.
I made an oversized pegboard wall organizer for my daughter's room. It's styled after a bunch of similar wall organizers that I had seen on Pinterest, using the spacing and peg-hole sizes commonly found on shop workbench dog-holes (3/4" holes, 4" on-center)
I know there are a lot of other wall organizers out there, but I am a believer in the strength of wood. If there's any interest in this kind of thing, be sure to share your print experience with me, I'd love to make more of these.