With built-in support

Additional hardware:
- 2 x 608zz ball bearings*
- 2 x M5 25mm button head bolts
- 2 x M5 T-nuts

* Not advice. Although this is designed with 608zz bearing in mind, in actual testing the bearing works too well and spin too far when tugged. This causes the spool to unwind and tangle. It is recommend that you use a printed bearing instead.

Spool Holder for 2020 aluminium extrusion

Spool_Pin.stl

Spacer_x2.stl

Holder.stl

Bearing_Pin.stl

Aligner.stl

Holder.step

Spool_Pin.step

Aligner.step

Spacer_x2.step

Bearing_Pin.step

This is an updated version from [v1](https://www.printables.com/model/370285-steam-deck-clip-on-stand). This version reduces the amount of support needed, and add adjust-ability and long term durability.

The clip-on stand hold the Steam Deck at 2 positions: 60-degree and 120-degree. In addition, it can clip on anywhere along the flat part in the middle of the Steam Deck, but will block some of the air intake/exhaust.

To prevent the clip sliding. Use electrical tape to line the inner-side of the bottom hook (of the clip).

**Print guide:**
Print orientation: As giving in the STLs
- Resolution: 0.2 mm for the clip / 0.1 mm for the stand and spring
- Infill: 40%
- Filament:  PETG is recommended, with PLA support interface (if possible)
- Brim: Clip - yes / Stand - no / Spring - no

**Buy me a coffee via:**
Ko-fi: https://ko-fi.com/a_vinny
Paypal: https://paypal.me/NVoChinh
BuyMeCoffee: https://www.buymeacoffee.com/a_vinny

SteamDeck Clip on Stand

SteamDeck - CoS-Clip-wt-headphone.stl

SteamDeck - CoS-Clip.stl

SteamDeck - CoS-Spring.stl

SteamDeck - CoS-Stand.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Gummy7336

Achievements

Seedling