Gecko Simple Dangle earrings.
These are a super simple, easy and QUICK file-an excellent choice to create something from those slim pickins spools (getting ready to run out or just not enough to use for major prints)
The 3MF has two different sets-one is spotted and the other is plain (for those without an AMS who want to do their own manual color changes)
This piece can be successfully sized up -depending on your need.. Can also be used to create a pendant to make an earring and pendant set.
Current size can use a 6mm/18 gauge jump ring for attaching
Print Time for color pattern - 80 min & for single color 24 min
P1P/ Bambu Basic Aux fan should be at or below 20% or turned OFF (if using one)
Settings First Layer .2mm Other layers .16mm Ironing is turned on for topmost surfaces Classic walls 3 wall loops 5 top shell 4 bottom shell 50 % Gyroid infill Initial Layer 35mm Initial Layer Infill 90mm
Prime tower enabled (suggest it be used on the pattern multi colored print) Brim/Bed Adhesion: None Needed Flushing set at default (you will need to adjust this for your filaments and machine type)